Poor surface formation of the weld is mainly manifested in two aspects: the surface of the weld seam is too high and the weld metal overflows

- May 16, 2018 -

Poor surface formation of the weld is mainly manifested in two aspects: the surface of the weld seam is too high and the weld metal overflows. The main factors affecting the weld formation in the welding process are the welding process parameters and the welding advance of the girth weld. When the current increases, the penetration depth and the residual height of the weld increase, the melt width is basically unchanged; when the voltage increases, the penetration depth decreases slightly and the melting width increases; when the welding speed increases, the line energy decreases. The penetration depth decreases slightly and the melting width increases. The remaining height decreases. Therefore, when the current is too large and the voltage is too low, the surface of the weld seam will be too large; when the welding speed is too slow or the voltage is too low, the weld metal will overflow. The molten pool in the horizontal position is the most stable and easy to get a good shape.

Previous: The generation of pores and inclusions in the welds is mainly caused by improper rooting, in addition to process reasons Next: Submerged-arc automatic welding is one of the high-efficiency welding methods widely used in welding production

Related Industry Knowledge

Related Products

  • Fused Submerged Arc Welding Flux HJ107
  • AWS E308L-16 Stainless Steel Welding Electrode
  • AWS E8015-B2 Heat Resistant Steel Welding Electrode
  • Stainless Steel Welding Wire AWS ER-410
  • AWS ER308LT-1 Flux Cored Welding Wire
  • CO2 Gas-Shielded Flux Cored Welding Wire AWS E71t-1