Home > News > Content

The Design Of The Orifice Is Too Large (especially For Profiles With Low Extrusion Ratio), Which Reduces The Pressing Force And Thus Reduces The Welding Force

- May 19, 2018-

The design of the orifice is too large (especially for profiles with low extrusion ratio), which reduces the pressing force and thus reduces the welding force. It is recommended that the edge of the orifice be at least 6-10 mm from the wall of the squeeze tube. Of course, the choice of the split hole and the structure of the splitter bridge will be considered together better.

Previous: Causes Of Severe Quilting 2.1 If The Pressing Force Is Too Low, The Welding Force Is Low Next: The Formation Mechanism Of The Weld Metal Is Divided Into Several Strands Through The Split Hole And Reassembled In The Weld Chamber

Related News

Related Products

  • Tungsten Carbide Welding Electrode
  • AWS E502-15 Heat Resistant Steel Rod
  • Fused Submerged Arc Welding Flux HJ330
  • BAg-5 Phos Copper Welding Wire
  • AWS E316L-16 Stainless Steel Welding Electrode
  • Gas Shielded Welding Gun